AB Designs

Time-pressure setup guides

Animated, step-by-step setup guides for a time-pressure filling system, built from a detailed 3D model so every clamp, gasket and sensor is shown exactly where it goes.

Role
Modelling, animation, guide design
Discipline
3D · Training · Motion
Built with
Blender, Premiere Pro
Used for
Operator training
The time-pressure system’s product tank and filling manifold, polished stainless on a blue ground
The project

Assembly steps you can watch, not just read.

Setting up a time-pressure filling system means fitting the product tank, supply piping, spray-ball piping, a level sensor and a pressure transmitter, each with the right clamp and gasket, in the right order.

Instead of a written procedure, each step became a short animated sequence with on-screen instructions: the part moves into place, the clamp closes, the caption says what to check. The guides are short enough to watch at the machine.

Setup guide Time-pressure filling systemChapter 01 / 06Step 1 of 5

Locate the mounting pin: pull, rotate, release

Smoke study over the assembled system